Tuesday, April 26, 2016

Modified Speedball Cutters

This post is long overdue.  What with moving and all, I sort of forgot about these until someone mentioned that they heard I had them.  So I went hunting, located them and took some pictures... finally!

These are Speedball Cutters that Kirbert has modified the same way that he modified the old Staedtler ones (yes, I have unearthed those, too, and will see if Kirbert still wants to modify them for me).  



This is the #1 miniaturized cutter.  The top of the cutting end has been ground down to allow for a much better view of exactly what (and where) you're cutting and a smaller tip to get into those really hard to reach places.  Do not confuse this with the so-called .5 blades that some people pinch - these have not been squeezed to narrow the valley of the blade, just made a lot more versatile for fine work. 


This is the #1 reversed cutter.  Look at how the top of the V is angled back from the point. This is a fine blade for getting into tight inside corners.  Shallow cuts are a must with this cutter, but it is a real help when carving letters.  I had to get used to this angled blade - it's easy for me to bury in the carving block if I don't keep my cuts shallow enough.  


This is the #2 miniaturized cutter.   Just like the #1 mini, the top of the V has been ground down to give better control and visibility - just with a slightly larger tip.  


Finally, this is a #4 miniaturized.  Once again, the top has been ground down to give a shallower, squared edge for removing larger areas, while still allowing the visibility needed to control how close you want to get to the image lines.  

I have a limited number of these to begin with, but if they look like they're going to be popular, I'll get another batch sent off to Kirbert for modification.  I sort of wanted to see what people were most interested in before getting too many of any one modification made, so I'll be watching how it goes.  

2 comments:

Anonymous said...

Have you tried the pinched .5 blades? They're narrower and shorter for fine work. To get narrow lines, you have to have a sharp narrow blade. Just a thought.

Webfoot said...

Thanks for your suggestion. I have tried pinching the blades, but too many of them crack along the way - I'm clearly no good at it! I don't think Kirbert likes to do those, either, so I don't have a source for them. If you know anyone who would like to modify .5 blades for me, I'd be delighted to know about it. :)